Centralized Workholding System with Repeatable Accuracy
|Model HXR 300
(with manual pump)
|Model HXR 50||Model PXR 100|
|Notice: The previous models MR/PR/HR 25 or MR/PR/HR 50 for the max. workpiece size OD=25 or 50 mm (1" or 2") are still offered by ARLA. It is also possible to purchase spare units (as far as possible) of other previous models including the necessary spare parts.|
The ARLA Clamping System is a centralized workholding system to clamp round workpieces (shafts, pipes, tubes) or any other symmetrical workpieces. Due to the mechanically synchronous clamping technology a high clamping force can be realized. Workpieces can be put into the system either axially or vertically. The accuracy according to the repeatability is within a tolerance of less than 0.01 mm. Models with either manual (M), pneumatic (P), or hydraulic (H) actuation are available. With reference to the workpiece design, changeable jaw sets are used. The movement of the actuation arms is monitored by sensors. Special accessories (universal clamping plates, swivelling workpiece stops with support and prismatic base, jaws completely manufactured) are also available. Typical applications of this centralized workholding system are found in endworking processes of pipes, tubes, and shafts (end preparation, end fabrication) and also in special-purpose machine tools (transfer lines, rotary indexing table and trunnion machines). ARLA also offers complete solutions for the endworking.
ARLA Clamping System: Model Overview
|The latest information on ARLA's machine products may be downloaded:|
You can also visit us on several international shows in order to see the latest state of ARLA's machine
tool technologies. The realization of ARLA machine products is presented
on our site "Applications".
Copyright © 2000-2012 ARLA Maschinentechnik GmbH - All rights reserved.